Fitment, Installation & Product Support

Use this guide to confirm vehicle fitment, find installation videos and instruction sheets for your Mohave Custom Design product, and get help when you need it.

Jump to: Installation Videos & Instructions · Confirm Fitment · Adhesive & Magnetic Installation · Returns & Support

Installation Videos & Instructions

Find your product below for its installation video and printable instructions. Each product name links to its product page with full fitment details.

No-Drill Magnetic Dash Mounts

These mounts share the same assembly and installation process.

Resources:

Low-Profile Dash Mounts

Resources:

Mercedes Sprinter Van Cup Holder Mounts

Ford Bronco 4-Door & Raptor Roll Bar Mounts

Resources:

Adhesive Steel Base Plates & Magnetic Hardware

Other Products

For products not listed above, installation guidance is on each product page. More videos are on the Mohave Custom YouTube channel. If you need help, contact us.

Confirm Fitment Before Ordering

  • Start with the correct vehicle collection.
  • Verify make, model, body style, roof configuration, trim, dashboard style, screen configuration, and factory mounting points listed on the product page.
  • For dashboard products, compare your vehicle with the product photos. Vehicle model alone may not guarantee fitment.
  • If compatibility is uncertain, contact us before ordering.

Wide and Narrow Dashboard Mounts

Measure the complete flat mounting area before ordering. The entire mounting footprint must sit on a compatible surface.

  • Wide: requires at least 2.75 × 5.7 in (70 × 145 mm).
  • Narrow: requires at least 1.8 × 3.75 in (45 × 95 mm).

Adhesive and Magnetic Mount Installation

  1. Measure and test-fit the mount and steel plates before removing the adhesive backing.
  2. Clean the mounting surface thoroughly with isopropyl alcohol and allow it to dry.
  3. Apply adhesion promoter when supplied and allow it to dry for approximately five minutes until tacky.
  4. Position the steel plates and press very firmly. Pressure helps the VHB adhesive form a secure bond.
  5. At room temperature, allow approximately 20 minutes for 50% bond strength, 24 hours for 90%, and 72 hours for full bond strength before maximum load.
  6. Attach the magnetic mount and confirm the Starlink Mini and all hardware are secure before driving.

Factory Mounting Points and Cup Holders

Confirm that the required threaded mounting point, roll-bar configuration, dashboard cup holder, or storage area matches the product photos and fitment details. Do not force a part into an incompatible location.

Safe Use

Confirm that the installed equipment does not obstruct visibility, airbags, controls, passengers, or safe vehicle operation. Recheck hardware and attachment points periodically and after rough-road use.

Returns, Damage, and Product Support

Unused products in original packaging may be eligible for return within 14 calendar days under the Refund Policy. Discounted blemish stock and custom products are not returnable. For damaged, incorrect, or potentially defective products, follow the timing and documentation requirements in the Shipping Policy and contact Mohave Custom Design with your order number and photos.

This support guide summarizes installation and fitment guidance; the published store policies control return and refund eligibility.

CONTACT US